Some Carbon Fiber Di Noc DIY

W

Wuufer001

Member
Location
TX
had a roll of the 3M Di-Noc CF at home not being used, so just thought of wrapping the below:smile (2):

dsc03012q.jpg

dsc03014c.jpg

dsc03015.jpg

dsc03016.jpg

dsc03017v.jpg

dsc03018zn.jpg

dsc03019t.jpg
 
Tks for all great feedback

Heat gun is not recommended, its 'required'
Without heat gun, its impossible

Have tried tucking the best by the edges, hopefully it stays put with the washing and the weather
 
Wuufer001 said:
Tks for all great feedback

Heat gun is not recommended, its 'required'
Without heat gun, its impossible

Have tried tucking the best by the edges, hopefully it stays put with the washing and the weather
Click to expand...

Is there no way you could have taken off that skid plate to make tucking the edges easier?
 
jcasanova said:
Is there no way you could have taken off that skid plate to make tucking the edges easier?
Click to expand...

That plate was installed by the dealer already when i got it, have no idead how its installed or remove it. Used the outer black plastic edge on the plate as a cover, withiut the outer plastic edge, i dont think it wouldve worked and looked as great
 
Looks great. Nice job. I'd be interested in updates as to how it holds up to the elements. Good thing is you can re-apply if it starts to look bad.
 
Wuufer001 said:
So far with the rain storm we had and the blazing sun, its holding up real good so far
Click to expand...

It will hold up for a while. I have a big 4x4 sheet at my house. And the heat gun makes it so much easier to apply and work with. Looks like you took your time doing it but it came out great. Nice DIY :tup:
 
You must log in or register to reply here.
Back
Top