head lights adjustment

Did you try using the adjuster inside the FX located on the dash? There is also an adjustment hole on top of the headlights itself.
 
Dr.2K said:
Did you try using the adjuster inside the FX located on the dash? There is also an adjustment hole on top of the headlights itself.
Click to expand...

you mean the "setting" section on the sreen?. I did that but it ditn't help. I'll try another method. THX.

---------- Post added at 09:14 AM ---------- Previous post was at 09:07 AM ----------

Dr.2K, theMerchant thank you all.
It is 6mm allen wrench.:smile:
 
I always run with the manual adjust on the left side of dash set all the way up unless I have so much weight in the back to cause lights to be to high.
 
Dr.2K said:
To the left of the dash you will see a roller knob with the numbers 0,1,2,3 next to it.
0=lowest setting and 3= highest setting
Click to expand...

I'll try................THX guys.

this how I did it before:
-Go to Settings ( on dash board ).
-Vehicle Electronic Systems.
-Sensitivity of Automatic Headlights.
( then adjust Lower ..... Higher )

Results nothing happened LOL.
 
Last edited:
So the best way to do this is:
1: set the level to 3
2: manually adjust each headlight to the level of preference.

Otherwise, if you adjust when you're at 0... Your 3 setting will point too high.

... Is that correct?
 
N2FX said:
So the best way to do this is:
1: set the level to 3
2: manually adjust each headlight to the level of preference.

Otherwise, if you adjust when you're at 0... Your 3 setting will point too high.

... Is that correct?
Click to expand...

I just found out that
0 is highest
3 is lowest.

I set it at 0 then use 6mm allen wrench bring it up manually to the level I comfortable with, from there I can use the knob inside.It works for me HAAHAAAAA.
 
easy_goer said:
I'll try................THX guys.

this how I did it before:
-Go to Settings ( on dash board ).
-Vehicle Electronic Systems.
-Sensitivity of Automatic Headlights.
( then adjust Lower ..... Higher )

Results nothing happened LOL.
Click to expand...

That adjustment is to control the sensitivity of when your lights comre on in auto mode.
 
Hello everyone,
I would like to refresh this subject again,
OK, don't have any questions about adjust head lights UP & DOWN.
But how about IN & OUT (left & right) ???????
your reply is appreciated.........
 
Last edited:
easy_goer said:
Hello everyone,
I would like to refresh this subject again,
OK, don't have any questions about adjust head lights UP & DOWN.
But how about IN & OUT (left & right) ???????
your reply is appreciated.........
Click to expand...

No adjustment is possible unless you remove your headlights, open them up and re-direct your projectors.

Why would you want to adjust left and right? Is it off? I've never heard of a projector being focused sideways, but it is possible.

We don't have "adaptive" headlights that turn as the car turns.
 
easy_goer said:
I had a scrash on the front end, after reinstall . They are not straight.
Just don't know what happened ??????:confused.:
Click to expand...

Can you clarify.

You had a front end crash. Then you re-installed headlights.

Did they laser align your frame? Your frame might be off-center and throwing everything else off.
 
You must log in or register to reply here.
Back
Top