B2 Auto Design V2 Spacers

P

per4m28

Member
Location
Central NJ
Car
FX35 2010
Name
B
Hi all, Just fitted these B2 Auto Designs V2 Spacers on a 2010 FX35 they seem to be in very good quality and finish. Fitment was good on all 4 corners. We installed 15mm fronts and 20mm rears. I talked with Charles for a bit about sizing as I was looking for a flush fit and if he recommended a particular sizing on 2nd gen, but was unsure for 2nd gen for a flush fit. So I went 15/20 to be safe and according to the measurements taken I should of went with 25mm to get a more of a flush fit. 15mm in the front looked to be almost flush maybe a very slight poke if that I think to be exact its about 12-14mm to be dead on flush thats with a 50mm offset wheel as 2nd gens have. Rears were a bit tuck at 20mm exact flush probably would of been more 22-24mm IMO. Here are a few before and after pictures sorry about the angles taken.
 
RIPnFX said:
I did 25mm in the rear and they are flush to a slight poke.
Click to expand...

RIPnFX yes I did read your post on the 25mm you installed but at the time I ordered this for some odd reason I couldnt find your post at the time or I would of ordered the 25mm and went with my measurements.
 
I would do 10-15mm in the front and either 20-25mm in the back. On my ride I went with 15mm front and 25mm rear and they sit flush with stock 21's.
 
You must log in or register to reply here.
Back
Top